INTRACOM            

jetSpeed 630+ Broadband Combo ADSL Router

ADSL/ADSL2+ with 4-port Ethernet switch and one USB interface

Specifications

Hardware

  • LAN Interface
  • Four 10/100 Base-TX Ethernet ports, IEEE 802.3u, RJ-45 connectors
  • Automatic 10/100M speed-sensing and MDI/MDI-X crossover detection-and-correction
  • One USB 1.1 device port, type B connector
  • WAN Interface (ADSL line)
  • One pair (2-wire) loop, 100 W line impedance with RJ-11 connector
  • Compliance of jetSpeed 630+: ITU-T G.992.1 (G.dmt), G.992.2 (G.lite), ANSI T1.413 Issue 2, ITU-T G.992.3 (G.dmt.bis / ADSL2) and G.992.5 (ADSL2+)
  • Indicators (LED)
  • PWR (green) - Continuous ON when power is properly connected
  • ALM (red) - indicates data error or operation fault
  • LAN (green) - Continuous ON when Ethernet is active; blinking while transmitting / receiving data
  • USB (green) - Continuous ON when USB link is active; blinking while transmitting / receiving data
  • WAN (green) - Continuous ON when ADSL link is up
  • OAM&P
  • Local: Telnet or Web management via Ethernet
  • Remote: Telnet or Web Management
  • Power
  • AC adapter: Input 110/220VAC, 50/60Hz; Output 15VAC 1A
  • Power consumption: Less than 10 Watts
  • Environment
  • Operation Temperature and Humidity: 0 ° C ~ 45 ° C, 5% ~ 95% (non-condensing)
  • Storage Temperature and Humidity: -20 ° C ~ 85 ° C, 5% ~ 95% (non-condensing)
  • Physical Dimensions
  • (W / D / H) 180 mm / 143 mm / 42 mm
  • Certificates
  • CE, CB

Software

  • ATM
  • ATM cells over ADSL, AAL5
  • Supports 8 PVCs under bridge mode and 5 PVCs under router mode
  • Supports UBR, CBR, rt-VBR and nrt-VBR traffic classes
  • SVC support: ATM forum UNI 3.0, 3.1 and 4.0 signaling; ILMI 4.0
  • Payload encapsulation
    - RFC2684 / 1483, Multiprotocol Encapsulation over ATM Adaptation Layer 5
    - RFC2225 / 1577, Classical IP and ARP over ATM (IPoA)
    - RFC2364, PPP over AAL5 (PPPoA)
  • Bridging
  • RFC2684 / 1483 bridged PDU encapsulation
  • IEEE 802.1D transparent bridging and spanning tree protocol
  • IP and PPPoE packet filtering
  • ZIPB (Zero Installation PPP Bridge) (*)
  • Supports 802.1p/Q prioritized tagged VLAN, with IGMP snooping option
  • Routing
  • RFC2684 / 1483 bridged and routed PDU encapsulations
  • Supports Point-to-Point Protocol (including PPPoA and PPPoE) and user authentication via PAP or CHAP
  • Supports TCP/IP, UDP, ARP, DHCP, IPCP, ICMP, etc.
  • IP routing: RIP v1, v2 and static routing
  • NAT/PAT with extensive ALG support
  • DNS relay
  • IP multicasting, IGMP and IGMP Proxy
  • Multihoming, IP aliasing, unnumbered IP interfaces
  • Virtual interface and secondary IP addresses
  • Supports IP QoS per RFC2474 / 2475 (*)
  • Configuration and Network Management
  • TR037-compliant auto-configuration using ILMI
  • SNMP v1, v2 and v3 agent – over IP, EOC and ILMI VCC
  • SNMP MIB II, DSL MIB and AToM MIB
  • DHCP client, server and relay for IP management
  • UPnP Internet Gateway Device (IGD v1)
  • Clients for SNTP v4 and SMTP
  • System log capability
  • Telnet with CLI (command line interface) or Web-based configuration and management
  • TFTP, HTTP for firmware upgrade and configuration
  • USB drivers for host PC / MAC
  • RNDIS drivers for Microsoft Windows 98, 98SE, ME, 2000 and XP
  • CDC Ethernet drivers for MAC OS 10.1, 10.2, X and Linux with kernel 2.4.18

(*) Optional feature. Can be provided at additional cost.

Specifications are subject to change without previous notice.